If you like the soft look of watercolors, why not try using a color wash on your walls? In addition to a softer color, color washing can accentuate the texture of your plaster or stucco walls. And it�s so simple that even I, a faux-finish-impaired decorator, can do it There are two techniques for color wash application: sponge or brush. Each requires a slightly different glaze formula. Sponge Technique: Color Wash Glaze: Mix together 1 part latex paint and 6 parts water in a bucket. 1. Mask off (using painter�s tape) parts of the room which will not receive the wash. Its best to cover the floor with plastic drop cloths (especially if you are as messy as I am). 2. Prime the wall with a low luster latex paint and allow it to dry completely before the next step. 3. Dip the sponge into the color was Kitchen Unit Doors h glaze and squeeze lightly. 4. Beginning in a lower corner, apply the glaze to the wall in short, overlapping strokes. Change the direction of the strokes frequently. Work on a small portion of the wall at a time (3 foot by 3 foot is a good size). 5. Repeat moving upward until the entire wall is covered. 6. Allow to dry completely. Brush Technique: Brush Color Wash Glaze: 1 part flat latex paint, 1 part latex paint conditioner (available at your local home improvement center), and 2 parts water. Mix in a bucket. 1. Mask off (using painter�s tape) parts of the room which will not receive the wash. Its best to cover the floor with plastic drop cloths. 2. Prime the wall with low luster latex enamel paint and allow it to dry completely before the next step. 3. Allow the paint to dry. 4.